Walker Ultra Hold Adhesive Hair Patch Glue | Hair Patch Adhesive PHC

Walker Ultra Hold Adhesive Hair Patch Glue

Walker Ultra Hold Adhesive : Hair loss problems are common among youngsters nowadays. This leads to hair thinning issues and baldness. If you are suffering from partial baldness, then it is not necessary for you to wear full-size wigs in order to conceal your hair loss regions. In this case, hair patch treatment can be used. Men and women suffering from Alopecia Areata which causes bald spots on the scalp often opt for this procedure as it is quite easy and simple.

It is a non-surgical procedure of hair restoration in which the hair replacement system is attached with the help of glue on the area of scalp where baldness has occurred. The walker ultra hold adhesive used in this treatment is safe and skin-friendly. It is one of the best methods to attach the hair system on your scalp at an affordable price. The hair patch blends seamlessly with your natural hairline and you look even better than before.

Silicone and Acrylic adhesives provide only 2 to 5 week wear time of hair system. But ultra hold glue provides 2 to 3 months wear time. Ultra Hold is Acrylic based clear non-yellowing glue. It is one of the most long-lasting glues available in the market. Features of ultra hold glue

• Skin-safe
• Clear when dry
• Waterproof

In this guide, we will walk you through the process of attaching a hair patch system with glue.

How to Use Walker Ultra Hold Adhesive

Step 1

Clean and prepare the patient’s scalp before attaching the hair system. It is essential to a secure bond so that it stays there only. Wash the entire section of the area where the hair patch is to be attached. After washing thoroughly, fully dry your perimeter area by a towel and/or blow dryer to remove all excess moisture.

Utilize a light pen to trace the contour of the lace system in order to know the actual size of the hair patch to be attached.

Step 2

The next step is to apply two thin layers of walker ultra hold adhesive on the scalp allowing 5 minutes rest between each coat. Make sure the first coat has dried completely before applying a second coat. Brush adhesive along the line you traced with a pen. When applying this glue, use thin, even layers and remember to apply in both directions – horizontal and vertical.

Since we use Walker Ultra Hold Adhesive wait for approximately 15 minutes after you have applied the second coat. Never try to apply glue directly to a hair replacement system. Rather, put it on the bald section on your scalp and place the system on your head.

Step 3

After the adhesive has dried, apply either scalp protector in case of ultra hold glue. Then gently place the hair system on the scalp and complete the process. Please keep your hair patch system dry for 24 hours after the procedure.

Conclusion 

Planet of Hair Cloning full-service is a leading provider of hair loss solutions like Hair Patches, Hair Wigs, Weaving, Bonding, and so on with easy to reach locations in Delhi.